
HDPE as a cutting surface
On your next time you’re going to be cutting green veggies on top of your cutting board, take time and check out it, the material most likely to be used as a HDPE Polyethylene Cutting Board Material – Sheets cutting board is Polyethylene. Because it can be FDA and National Sanitation Foundation approved not to mention stain, moisture and odor resistant, Polyethylene is the perfect choice for slicing boards.
Other types of cutting boards cut from wood are susceptible to bacteria and residual odors because they lack the desiredproperties that Polyethylene sheets offer, which include its non permeable surface, chemical resistance and approval for food contact. High Density Polyethylene is certainly an durable and lighter weight material that comes in lots of forms and is well suited for a wide range of applications. There are many different types of Polyethylene commercially available. The most common are HDPE (High Density Polyethylene), Low Density Polyethylene, and UHMW (Ultra High Molecular Weight Polyethylene). The difference has to do with the molecular weight and branching;Â which is when a monomer or atom is replaced by a longer chain of polymers (an excessively long repeating chain of atoms). Â
{|
|
|
|
The High Density is often used for milky white gallon milk jugs and food containers. Low Density is commonly used for containers as well as plastic baggies. UHMW, which has higher molecular weight (2-6 million) which enables for an even transfer over the length of material which makes it stronger, which makes it able to be used with regard to bearing products for the great wear resistance. Commonly utilized in the food processing and dairy industry, Ultra High Molecular Weight Polyethylene is really a good replacement for a number of other industrial materials and a great technique to many wear issues.  Most of these polymers are produced from the same polyolefin plastics family, but all have certain properties that make them just a little different. HDPE provides great chemical resistance, has very high impact strength and great energy absorption. LDPE has lots of of the same properties as High Density however it’s not as dense at 9.15, the lowest in comparison to HDPE which is 9.34, and it is a softer material ( the one gallon coffee can lids). It also has a lower tensile strength as well as improved, less complicated heat processing.
UHMW is a strong material that has great durability and low co-efficient of friction which make it an ideal for sliding applications. One of the only plastic material with a lower co-efficient of friction is Polytetrafluoroethylene – PTFE; which has a higher temperature and chemical resistance. Ultra High Molecular Weight Polyethylene comes with a lot of material solutions and properties, and most of these materials possess exceptional longevity which might be well suited for a variety of applications. From the food industry to automotive, your kitchen in addition to warehouse, whatever your Polyethylene needs are – High Density, Low Denseness or even UHMW, Polyethylene is a superb option. Email us for additional information on these and other plastic raw materials.